2006 Dodge Pickup
Mileage
162,285
Service Date
7/3/2020
Services Performed
- Complete hookup & analysis on Scope or Scanner 1. Confirm problem : YES 2. Monitors : OK 3. Computer codes : P0713- TRANS TEMP SENSOR 1 HIGH 4. Mode 6 data: PASS 5. Visual test : N/A 6. Engine vac. @ idle : N/A 7. Engine vac. @ 2500 : N/A 8. Smoke test : N/A 9. Diagnostics : PULLED CODE P0713- TRANSMISSION TEMPERATURE SENSOR VOLTAGE TO HIGH. CODE SETS WHEN TRANS TEMP SENSOR VOLTAGE GOES ABOVE 3.76V (HOT) FOR 2.2 SECOUNDS, WHEN CODE SETS PCM WILL USE A FORMULA DERIVED FROM ECT VOLTAGE AS DEFAULT VALUE FOR TRANS TEMP. IF TRANS TEMP READS ABOVE 266 DEGREES OVER DRIVE WILL BE DISABLED. TCC SOLENOID WILL GO OPEN. DISCONNECTED 23 WAY CONNECTOR AT TRANS, GROUNDED TRANS TEMP SENSOR CIRCUIT, VOLTAGE READS 0 WHICH INDICATES WIRING FROM CONNECTOR TO PCM OK. OHMS TESTED DARK GREEN AND ORANGE WIRE FROM CONNECTOR TO PCM., READS 0.2, GOOD VOLTAGE AT SENSOR WHEN CONNECTED IS 5V, INDICATING SENSOR OR WIRING INSIDE OF TRANSMISSION IS BAD. REMOVED TRANSMISSION OIL PAN AND REPLACED TRANSMISSION TEMPERATURE SENSOR, ALONG WITH TRANS FILTER AND PAN GASKET. FILLED TRANS WITH FLUID AND MONITORED SENSOR WHILE ON TEST DRIVE. SENSOR NOW READS 2.3 VOLTS WITH NORMAL RANGE DURING TEST DRIVE. TRANS SHIFTS INTO ALL GEARS AND OVERDRIVE WORKING AT THIS TIME. 10. Confirm fix: YES Tire Pressure F= 65PSI R= 65PSI Complementary inspection Air filter – OK Cabin filter – OK Belts – OK Hoses – OK Engine oil – OK Engine coolant – OK Tires – RF__8/32 LF__8/32 RR__8/32 LR__8/32 Tire Date codes – 2019 Visual Brake inspection – F___7MM R___5MM
- FLUID TEMPERATURE SENSOR – Remove & Replace – 4WD – [Includes: R&I Valve Body Assembly.]
Kate D. gave our service a 5 star review on 7/3/2020
