2012 Honda CR-V
Mileage
132,538
Service Date
9/11/2024
Services Performed
- Today's temp: 75 0. Confirm Problem – no 1. Freon content in % – R134 2. Recovered amount: 9oz Spec- 15oz Needed- 6oz 3. Vacuum test: -30 4. After 10 minutes: -29 5. Check oil drain bottle after recovery: yes 6. Check compressor oil level: 7. Oil Type: Pag 8. Recharged with: 15 oz R134a 9. Pressure – Highside 110 Lowside 10 10. Vent outlet temp: 55 11. Test for leaks with electronic leak detector: yes 12. Fan works: Yes 13. Belts: OK 14. Comments: Low on freon, however no leaks were detected. Added dye to refrigerant so leak can be detected is system runs low again. After Fill/Repair: Vacuum:__-30____After 10 Minutes____-29____ Low Psi__25___High psi__150____A/C Temp___39.9______ A/C Temp. @ vent now reading during test drive: 37.9 Complementary Inspection Air filter – OK Cabin filter – OK Belts – OK Hoses – OK Engine oil – OK Engine coolant – OK Tire Pressure – 32 Tires – RF__8___LF__8___RR___5___LR___5___ Tire Date codes – '18, '23 Visual Brake inspection – F____4______R_____4____
- Added dye to refrigerant
- Pulse/Shimmy: NO Brake Pull: NO Brake Pads/Shoes: (MM) RF____2______LF_____1_____RR_____1_____LR_____2_____ Emergency Brake Shoes LR____4______ RR______4______ Disc Front – Spec:___23_______Rear – Spec_____7.5_____ RF____24.13____LF___24.05_____RR___8.25_____LR____8.35_____ After Machining: RF___23.84_____LF____23.8____RR___7.78_____LR____8.04_____ Surface________________________________ Wheel Bearings: OK Hydrualics – Master Cyl: Ok Front Calipers: OK Rear Calipers / Wheel Cyls: OK Brake Lines: OK Wheel Torque___80________Ftlbs Tire Pressure – F= 32 R= 32 Brake Fluid Condition: OK Front Suspension: OK Rotor runout, if necessary: Rotor Parrelism, if necessary:
- Brake work recommended was performed, thus brake inpection fee is waived.
- BRAKE PADS – Remove & Replace – All,Both Axles – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
- Measure brake rotors size to determine that they are able to be machined. Machine rotors using a brake lathe. Before machining size After machining size
Beth K. gave our service a 5 star review on 9/12/2024
