mitchell1

2011 Ford Edge

CRM Mitchell1 2021-04-08T22:02:10+00:00

Mileage

110,210

Service Date

4/6/2021

Services Performed

• Test drove vehicle felt like air was in the system. Performed ABS automated bleed now the vehicle has GOOD pedal high and hard. TIRE PRESSURES @ 35psi front and 35psi rear

 

Barb Y. gave our service a 5 star review on 4/7/2021

2011 Ford Edge CRM Mitchell1 2021-04-08T22:02:10+00:00

2013 Cadillac XTS

CRM Mitchell1 2021-04-07T22:04:02+00:00

Mileage

91,814

Service Date

4/6/2021

Services Performed

• California Battery Fee
• Installed customer supplied battery Charging now at 14.6volts

 

Susan V. gave our service a 5 star review on 4/6/2021

2013 Cadillac XTS CRM Mitchell1 2021-04-07T22:04:02+00:00

2020 Subaru Outback

CRM Mitchell1 2021-04-06T22:02:08+00:00

Mileage

24,733

Service Date

4/5/2021

Services Performed

• AXLE BOOTS & JOINTS – INSPECT – [When the vehicle is used under severe conditions, check every 6 months or 9,600 km (6,000 miles).] – OK BRAKE SYSTEM – INSPECT – [Inspect: Brake line, Disc brake pad and disc, Parking brake. When the vehicle is used under severe conditions, check every 6 months or 9,600 km (6,000 miles).] – OK STEERING COMPONENTS – INSPECT – [When the vehicle is used under severe conditions, check every 6 months or 9,600 km (6,000 miles).] – OKJ SUSPENSION COMPONENTS – INSPECT – [When the vehicle is used under severe conditions, check every 6 months or 9,600 km (6,000 miles).] – OK CABIN AIR FILTER – REPLACE – [When the vehicle is used under extremely dusty conditions, the air cleaner element and A/C filter should be replaced more often] – OK ENGINE OIL – REPLACE – [When the vehicle is used under severe conditions, replace the engine oil and engine oil filter every 3 months or 4,800 km (3,000 miles).] – OK ENGINE OIL FILTER – REPLACE – [When the vehicle is used under severe conditions, replace the engine oil and engine oil filter every 3 months or 4,800 km (3,000 miles).] – OK TIRES – ROTATE – [A tire should be replaced when the tread wear indicator appears as a solid band across the tread; this occurs when the remaining tread has worn to 0.063 inches (1.6mm) or less.] – OK
• Changed oil and oil filter. Lube Chassis & Driveline Check sheet: Transmission fluid: ok Radiator water: ok Windshield wiper fluid: ok Wiper Blades ok Battery water: ok Battery Date ___Covered___ Brake fluid ok Hyd. clutch fluid: N/A PS fluid: ok Air filter: ok Cabin Filter: OK Belts: ok Hoses: ok Shocks & suspension: ok Chassis lubrication: ok Oil leaks: ok Lights: ok Tires: ok Tire Date Codes – 19/20 Tread depth – LF_6___RF___6___LR__10__RR__10____ Air Pressure F=___35___R=___33___ Oil Sticker: Door RESET OIL LIFE MONITOR____NA_____ Front Brakes: ok – _6mm__ Rear Brakes: ok – ___4mm__ Wheel Torque – ___85ftlbs___
• MILEAGE – ALL MAINTENANCE @24,000 MILES – All Applicable Models

 

NORMAND R. gave our service a 5 star review on 4/5/2021

2020 Subaru Outback CRM Mitchell1 2021-04-06T22:02:08+00:00

2006 Toyota Highlander

CRM Mitchell1 2021-03-24T22:02:08+00:00

Mileage

169,288

Service Date

3/22/2021

Services Performed

• (Right Rear)- window regulator slider channel has slid out of adjustment, Re positioned window to proper position on regulator channel. Also found during window inspection, right front window is going up and down slower than normal. Reassembled & checked operation ok at this time.
• Tire Pressure – 32 psi

 

Kenna C. gave our service a 5 star review on 3/23/2021

2006 Toyota Highlander CRM Mitchell1 2021-03-24T22:02:08+00:00

2011 Infiniti G37

CRM Mitchell1 2021-03-19T22:03:53+00:00

Mileage

129,613

Service Date

3/18/2021

Services Performed

• Air filter – OK Cabin filter – OK Belts – OK Hoses – OK Engine oil – OK Engine coolant – OK Tire Pressure – 35/35 Tires – RF__3mm__LF___3mm___RR__4mm____LR__4mm____ Tire Date codes – 2020/2019 Visual Brake inspection – F_5mm__R___5mm__ Right front tire low
• Removal of all Intoxalock products Removed Intoxalock S/N R35302

 

Elijah G. gave our service a 5 star review on 3/18/2021

2011 Infiniti G37 CRM Mitchell1 2021-03-19T22:03:53+00:00

2013 Toyota Tacoma

CRM Mitchell1 2021-03-13T23:04:30+00:00

Mileage

199,734

Service Date

3/12/2021

Services Performed

• CABIN AIR FILTER – Remove & Replace
• Changed oil and oil filter. Lube Chassis & Driveline Check sheet: Transmission fluid: ok Radiator water: ok Windshield wiper fluid: ok Wiper Blades ok Battery water: ok Battery Date code__Covered__ Brake fluid ok PS fluid: ok Air filter: ok Cabin Filter: Dirty Belts: ok Hoses: ok Shocks & suspension: ok Chassis lubrication: ok Oil leaks: ok Lights: ok Tires: ok Date codes: 2019 Tread depth – LF_10mm___RF__10mm__LR__10mm__RR__10mm___ Air Pressure F=_35__R=___35__ Visual Brake inspection F=__8mm__ R=__Drum___ Oil Sticker: Windshield Door RESET OIL LIFE MONITOR_________
• Tire Pressure:

 

Bret W. gave our service a 5 star review on 3/12/2021

2013 Toyota Tacoma CRM Mitchell1 2021-03-13T23:04:30+00:00

2016 Scion iA

CRM Mitchell1 2021-03-11T23:06:23+00:00

Mileage

168,158

Service Date

3/10/2021

Services Performed

• * Remove battery – OK * Wash with soap & water – OK * Clean battery cable terminals with baking soda – OK * Coat terminals & any exposed metal with paint – OK Battery date code – Covered Parasitic Draw= 0.013 milli amp Running voltage loaded= 10.7
• Air filter – Dirty – declined not at this time. Cabin filter – Dirty – declined not at this time Belts – Alternator belt broken Hoses – OK Engine oil – OK Engine coolant – OK Tire Pressure – 35/35 Tires – RF___2mm__LF__2mm____RR_5mm_____LR___5mm___ Tire Date codes – 2016 Visual Brake inspection – F__5mm__R__Drum__ Recommend 2 front tires Recommend Diag for TPMS light.
• Battery Date code – Covered 1. Battery voltage not loaded : 12.12v After repairs: 12.5 2. Battery voltage loaded : 8.80 After repairs: 10.7 3. Battery water : Full 4. Battery specific gravity : .100 5. Battery overall condition : Dirty 6. Battery cables condition : Dirty 7. Positive battery cable voltage drop : .02v 8. Negative battery cable voltage drop : .03v 9. Starter draw : 25amp 10. Starter Solenoid voltage drop : .02 11. Starter solenoid voltage : 12.09 12. Alternator voltage output @ idle : 13.88 After repairs: 13.88 13. Alternator voltage output @ 2500 : 13.85 After repairs: 13.86 14. Alternator voltage output loaded @ idle : 13.91 After repairs: 13.91 15. Alternator field voltage : 10.5 16. Alternator amperage output :30AMP 17. Alternator diode pattern : OK 18. Parasitic draw : 0.013milli amp 19. Diagnostics : Alternator belt broken. 20. Problem confirmed : Yes
• Removed torn alternator belt. Checked all pulleys, they all turn freely. Installed New Alternator belt. Once vehicle was repaired and running, found TPMS light is on. Recommend diag for TPMS light.

 

Shaun R. gave our service a 5 star review on 3/10/2021

2016 Scion iA CRM Mitchell1 2021-03-11T23:06:23+00:00

2019 Chevrolet Camaro

CRM Mitchell1 2021-03-09T23:00:46+00:00

Mileage

33,385

Service Date

2/10/2021

Services Performed

• Racked vehicle on rack, moved through suspension range – up & down – no more vibrations or noises. Rechecked all joints & mounting points, re neutralized suspension, retorqued all mounting points to 80ftlbs. Checked front suspension, loosened, neutralized and retorqued to 80ftlbs. Checked and tightened front and rear subframe bolts to 80ftlbs. Test drove vehicle in church parking lot with customer – no noises at this time, test drove same no noises. Brake pedal feels good and solid, pedal height is also good.

 

STEVE H. gave our service a 5 star review on 3/9/2021

2019 Chevrolet Camaro CRM Mitchell1 2021-03-09T23:00:46+00:00

2007 Honda Odyssey

CRM Mitchell1 2021-03-05T23:01:07+00:00

Mileage

102,255

Service Date

3/1/2021

Services Performed

• 1. Wash headlight lens to remove surface dirt OK 2. Mask off any areas to be protected OK 3. Apply compound over entire lens using firm pressure. OK 4. Buff W/clean cloth. OK 5. Dry the lens W/cotton towel. Apply lens clarifying compound and rub thoroughly back and forth until lens clarifies. Let compound dry to a haze and buff W/cotton cloth. OK 6. Apply lens sealing wipe, coat the newly restored lens. Coating will dry & cure within 24hrs. OK
• Air filter – OK Cabin filter – OK Belts – OK Hoses – OK Engine oil – OK Engine coolant – OK Tire Pressure – 35 Tires – RF__7___LF___7___RR___8___LR__8____ Tire Date codes – 19 Visual Brake inspection – F___1mm____R____4mm____
• Brake work recommended was performed, thus brake inpection fee is waived.
• Inspected glove box. Removed mounting bolts off the bottom of glove box. Pushed latch down with a screwdriver and found arm inside latch assembly is bent, not allowing latch to open. Recommend replacing glove box latch assembly.
• Measure brake rotors size to determine that they are able to be machined. Machine rotors using a brake lathe. Before machining size: 10.83 After machining size: 10.24
• Pulse/Shimmy:Yes_____NO___X__Front_____Rear_____ Brake Pull: YES_________NO___X___ Brake Pads/Shoes: (MM) RF___1mm___LF____2mm______RR____4mm___LR__4mm____ Emergency Brake Shoes LR____5mm______ RR_____5mm____ Disc/Drum Front – Spec:___26mm___Rear – Spec_____9mm_____ RF___26.02_____LF____26.37____RR__10.83___LR___10.84____ After Machining: RF____N/A____LF___N/A_____RR____10.24____LR____10.18_____ Surface______Good_____________ Wheel Bearings: OK____X______Not ok_______ Hydrualics – Master Cyl: Ok___X__Not ok______ Front Calipers: OK____X_____Not OK_____ Rear Calipers / Wheel Cyls: OK____X_____Not ok______ Brake Lines: OK___X____Not ok________ Wheel Torque_____87______Ftlbs Tire Pressure – F= 35 R= 35 Brake Fluid Condition: OK__X___Not OK____ ppm =____N/A___ Front Suspension: OK___X__Not OK______ Rotor runout, if necessary: Rotor Parrelism, if necessary:
• Removed tires. Removed front and rear brakes pads. Cleaned surrounding area. Cleaned and lubed brake pads. Installed new front and rear brake pads. Found front rotors just over minimum spec, if resurfaced, front rotors would be under the required thickness. Removed front rotors. Cleaned rotors and surrounding area. Installed new front brake rotors.

 

Laura D. gave our service a 5 star review on 3/4/2021

2007 Honda Odyssey CRM Mitchell1 2021-03-05T23:01:07+00:00

2018 Hyundai Tucson

CRM Mitchell1 2021-03-03T23:00:36+00:00

Mileage

48,750

Service Date

2/15/2021

Services Performed

• Found that the right front low beam headlight bulb shorted out due to one of the wires breaking or heating off the designated mounting slot. There are multiple burned spots on the bulb mount and wire. Replaced pigtail connector added heat shrink and electricians tape. Removed old bulb replaced with New Bulb.

 

Donald M. gave our service a 5 star review on 2/27/2021

2018 Hyundai Tucson CRM Mitchell1 2021-03-03T23:00:36+00:00